The part is the support of the whole machine tool, and its precision maintainability is very demanding. Therefore, this article focuses on the characteristics of the heat treatment of the bed parts, roughly boils down to the following points:
(1) The use of steel for general use of non-alloy (carbon) structural steel and alloy structural steel. A few parts, such as inlaid steel rails, hardened screws, etc., use low-alloy tool steel and bearing steel.
(2) The salt bath furnace is used for non-oxidizing heating of most parts of the cycle-type furnace. Vacuum furnace or kerosene drip in a gas carburizing furnace to create a protective atmosphere.
(3) Partially hardened and surface hardened parts There are many machine tool parts that only require high wear resistance on the part of the surface. Except that a few parts are partially hardened by a salt bath furnace, most of the parts use local surface quenching methods (such as Induction heating, laser heating, ultrasonic heating, etc.) Hardening.
(4) Precision parts require high dimensional stability Usually, one or more stabilization treatments are often arranged in the process, such as stress relief annealing, low-temperature aging treatment, and cold treatment, to minimize the residual internal stress and ensure high dimensional stability. Sex.
(5) Widely used low-temperature chemical heat treatment machine tool parts are mostly designed from the perspective of rigid, heat treatment requirements become smaller, high wear resistance and good dimensional stability. Therefore, nitriding, nitrocarburizing and other low-temperature chemical heat treatment process has been widely used.
(6) Most steel parts must undergo pre-heat treatment such as castings, forgings, and rolled materials. They must be pre-treated by annealing, normalizing, or tempering to increase their strength, eliminate defects in the structure, and improve processing performance. : At the same time, prepare the organization for the final heat treatment to reduce heat treatment distortion.
We can provide various type of and different capacity Plastic Color Mixer Machine/plasic color mixer. The Plastic Mixer machine/ Plastic Mixing Machine have two type, screw type hopper mixer/Screw Type Plastic Mixer and vertical paddle type mixer/ Vertical Batch Mixer . We have diifferent model mixer for customers' selection, 20KG, 50KG, 100KG, 150KG, 200KG, 300KG, 500KG, 600KG, 100KG, etc. For screw type hopper mixer, we can fix heating elements for drying fuction, so that customers can mix and dry material at same time, to get a perfect efficiency.It's same as Plastic Mixer With Dryer.
The volumetric dosing unit are used to feed plastic masterbatch into injection molding machine in a certain proportion.
Plastic Mixer,Automatic Dosing Units,Plastic Color Mixer Machine,Plastic Mixing Machine,Plastic Mixer With Dryer,Vertical Batch Mixer,Screw Type Plastic Mixer
Ningbo Rainbow Plastics Machinery Co., Ltd. , http://www.injection-machine.com