China Vacuum Pump Trading Network News /
(1) Overall structure of the pump The arrangement structure of the pump body of the type vacuum pump determines the overall structure of the pump.
The horizontal structure of the inlet and outlet openings of the vertical structure makes it easier to assemble and connect the piping. However, the center of gravity of the pump is high, and its stability is poor at high speeds, so this type is mostly used for small pumps.
The inlet of the horizontal pump is at the top and the exhaust port is at the bottom. Sometimes it is convenient to install and connect the vacuum system pipes. The exhaust ports can be taken out from the horizontal direction, that is, the inlet and exhaust directions are perpendicular to each other. At this time, the exhaust port can be opened in either left or right direction except for one end of the exhaust pipe, and the other end is blocked or connected to the bypass valve. This type of pump has a low center of gravity and good stability at high speeds. Generally large and medium-sized pumps use this structure.
The two rotor shafts of the pump are mounted perpendicular to the horizontal plane. This kind of structural assembly clearance is easy to control, the rotor assembly is convenient, and the pump has a small footprint. However, the higher the center of gravity of the pump and the inconvenience of disassembling the gear, the lubrication mechanism is also relatively complicated.
(2) Transmission mode of the pump The two rotors of the vacuum pump are relatively synchronously operated by a pair of high-precision gears. The drive shaft is coupled to the motor via a coupling. There are mainly two kinds of transmission structure layouts. One is that the motor and gear are placed on the same side of the rotor as shown in the figure. The driven rotor is directly driven by the motor end gear, so that the torsional deformation of the active rotor shaft is small, the gap between the two rotors is not changed due to large torsional deformation of the drive shaft, so that the gap between the rotors is running. Uniform in the process. The biggest disadvantages of this transmission method are: a. There are three bearings on the drive shaft, which increases the difficulty of processing and assembly of the pump, and disassembly and adjustment of the gear are inconvenient; b. The overall structure is uneven, and the center of gravity of the pump is biased toward the motor and gears. Side of the box.
Features (1) Larger pumping speed over a wider pressure range;
(2) The rotor has a good geometrical symmetry, so the vibration is small and the operation is smooth. There is a gap between the rotor and between the rotor and the housing, no lubrication, small friction loss, can greatly reduce the driving power, which can achieve higher speed;
(3) No oil sealing and lubrication inside the pump chamber can reduce the pollution of the vacuum system by oil vapor;
(4) There is no compression in the pump chamber and no exhaust valve. Simple and compact structure, insensitive to dust and water vapor in the exhausted gas;
(5) The compression is relatively low, and the effect of pumping hydrogen is poor;
(6) The surface of the rotor is a curved cylindrical surface with complex shapes, making machining and inspection more difficult.
/
SME Metal Pump Parts are made of high chrome white iron, grey cast iron or stainless steel. Especially the wet-end parts,
which are made of various chrome alloys to suit different slurry applications.
Features
1. Scientific design based on hydraulic theories;
Materials: A05, A33, A49, G01, G02, C21, C23, J04, J05
Metal Pump Parts
Metal Pump Parts,A05 Slurry Pump Parts,A49 Pump Parts,Abrasion Resistant Pump Parts
Shijiazhuang Minerals Equipment Co., Ltd , http://www.smepump.com