Distiller application notes

Distillers are very common as a kind of distilled water heating equipment. In the process of use, cold water is also needed to meet the needs and can not be interrupted. Otherwise, the heater will be damaged due to dry burning. Therefore, installing a set of water cut off automatic protection device to the distiller can ensure the safe operation of the distiller under sudden water cut.

After the entire distiller device is installed, the valve of the water supply pipe is opened, and the water enters the cylinder body from the upper inlet of the right cylinder body. After decompression of the right cylinder, water enters the left cylinder from the lower communicating tube. Part of the water enters the distiller through the lower nozzle. The other part of the water lifts the float in the cylinder under the action of buoyancy. At the same time, the iron flag on the pull cord left the proximity switch and moved to the left end of the bracket. When the iron flag leaves the proximity switch, the contact point of the proximity switch actuates the contact point of the main circuit and sends power to the distiller to begin work. When the water supply line interrupts the water, the water in the left cylinder gradually decreases, causing the float to fall to the bottom of the cylinder. At the same time, the iron flag is pulled back to the right end, giving a signal to the proximity switch to make the contact point of the main loop of the control circuit act, cut off the power supply of the distiller, and the distiller stops working, which plays a role of water cut control and protection.

The distiller device achieves the intended purpose through installation and commissioning, and realizes automatic control and protection of the entire process. Sensitive action, reliable performance, economical and practical; to achieve a continuous water preparation, improve the efficiency of the distiller, save energy; proximity switch selection should be based on the main circuit load and control circuit load size selection. In this example, a 6 kW distiller is used. The size of this type of proximity switch is slightly larger and should be reselected as required.

Any way, Super Scanner Metal Detector is actually Metal Detector, with copper cirlce inside. And use battery or adapter to make it work. When detect metal, it will warm as vibrating, screaming or lighting. Hand-Held Metal Detector protect people's life from being hurt and property being damaged by terrorism. Chinese Held held metal detector is cheap but also good in use. And also offer 1 year warranty, it worth your choice! 

Super Scanner Metal Detector

Super Scanner Metal Detector,Super Hand Held Body Scanner,Safe Guard Scanner Detector,Super Scanner Handheld Metal Detector

Shenzhen Mama Security Technology Co., Ltd. , http://www.mamasecurity.com